X-Carve

About

The X-Carve is a CNC router by Inventables that is beginner friendly and very easy to use. It is run by the cloud based software Easel, also from Inventables, which requires a free account to use. HackRVA has a pro account available to use while at the space that allows access to all premium features in the software. The router is a standard Dewalt 611 router that takes 1/8" and 1/4" bits. No metal cutting.

Current Specs:
Pre 2021 model w/ 2021 Upgrade Kit
Bed Size: 1000mm²
Cuttable area: 27"

wide makerslide Direct Z drive
9mm 3GT belts
212oz NEMA 23 stepper motors

General Use

A vacuum is wired into the switch that controls the router. Without the vacuum, large amounts of fine dust are generated.
The bed is a board with a grid of threaded holes. Hold down devices are attached to the bed with thumb screws. All of thes are in small bins along the front of the bed. A waste board must always be used when cutting to prevent damage to the bed.

More Info

HackRVA Quick Start Guide
Inventables X-Carve 1000mm
User manual
Easel (application that runs the Xcarve)
Easel Learning Resources for Beginners