3D Printing
HackRVA has three 3D printers in residence: a Prusa i3 MK2, an Ultimaker 3 and a Form 1+. The Form1+ is a resin type 3d printer that uses a liquid photopolymer that is selectively hardened by a UV laser on the bottom of a clear tank. The makerspace usually has a selection of generic filament for occasional use. Members should provide their own filament if they are printing a large project or require a specific type.
Here’s a short comparison of the four printers:
| Prusa i3 MK3 | Ultimaker 3 | Form 1+ | |
|---|---|---|---|
|
|
| |
| Number of Print Heads | 1 | 2 | 1 |
| Build Platform Envelope | 250 x 210 x 200 mm | 215 x 215 x 200 mm Single 197 x 215 x 200 mm Dual |
165 x 124 x 124 mm |
| Heated Build Platform | Yes (Max 120°C) | Yes (20°C to 100°C) | no |
| Filament Normally Loaded | 1.75mm PLA, ABS, PETG | 2.85mm PLA, ABS, PETG | Photopolymer Resin |
| Nozzle Diameter | 0.40mm | 0.40 mm, 0.80 mm | 405 nm |
| Build Speed | up to 15 mmᶟ/s | up to 24 mmᶟ/s | 1-3 cm/hr |
| Resolution | 50 microns | 20 microns | 25 microns |
| Typical Print Layer Thickness | 0.3 - .05mm | 25 - 100 μm | |
| Printing Temperature | Max 300°C | 180–280°C | 18–28°C |
| Web Site | Prusa i3 MK3 | Ultimaker 3 | Form 1+ |
| User Manual | Manual | Manual | Support |
| Hack.RVA Wiki | Ultimaker 3 | Form 1+ | |
| Firmware Version | 3.11.0 | 5.3.0.0 | N/A |
| Serial No. | CZPX2817X003XK26782 | BPP-003840-027155 | Sassy Leveret |
| Software | PrusaSlicer | Cura | Pre Form 2.20 |