Kramers tricopter step by step

Kramer's Documentation at end of day one 1/31/15 essentially unintelligible, but I'm tired.

- Legs

 - sanded Legs
 - Assemble Motors 
   - attach the bottom braket
     - get counter sink side correct
 - Attach 2 non-servo motors to legs
   - opposite side of screw holes
   - align wires with opening
   - use small cutout to enclose wires within leg slot
     - could glue
   - zip tie in place

-

   - Zip tie and connect speed control
   - will need to determine direction after build by running the motor and noting direction so don't make permanent

-

 - drill and file 3D printed gimble mount
   - use a screw and glue the end to make gimble pivot

-

   - use super glue
 - screw motor on 3D printed mount
   - may need to drill to fit
   - align wires away from base end

-

 - Attach servo
   - use drill to reverse counter sink screw hole to get a flush connection
   - cut two edges of servo star to fit
   - ensure full range of motion and attach star to servo
   - superglue to gimble

-

 - Attach gimble and servo to leg
   - Found out I made a mistake in how the wires were aligned with cutout on leg
     - inscrewed and screwed
   - use zip ties
   - used super glue for spacer after zip tie

-

 - zip tie and connect speed controller

- Put the screws in a center piece and attach legs putting the gimbled leg in the center

 - use shorter 1 1/4 inch screw on inside for gimbled leg
 - attach so that the motors face down and the wires are accesable 

-

- connect wires together in middle using solder and speaker wire

 - pigtail all negative and positive from the speed controllers
   - cut and strip black and red wires 
   - cut and strip speaker wire
   - cut shrink wrap and solder wire red to red black to black

-

   - lighter for shrink wrap
   - combine all neg and wire to neg for final wire
   - do the same for pos
   - don't forget skrink wrap(large)
 - Extend all control wires 
   - only the white wire from the two legs without the gimble
   - all three from the gimble
   - leave about 4 inches past the hole through the center section to the top
   - takes a while; don't forget the shrink wrap
 - attach the top plate
   - I messed up the side I soldered the large wires and had to flip the legs to make the bottom plate the top

-

-