3D Printing

HackRVA has three 3D printers in residence: a Prusa i3 MK2, an Ultimaker 3 and a Form 1+. The Form1+ is a resin type 3d printer that uses a liquid photopolymer that is selectively hardened by a UV laser on the bottom of a clear tank. The makerspace usually has a selection of generic filament for occasional use. Members should provide their own filament if they are printing a large project or require a specific type.

Here’s a short comparison of the four printers:

	Prusa i3 MK2S	Ultimaker 3	Form 1+
Number of Print Heads	1	2	1
Build Platform Envelope	250 x 210 x 200 mm	215 x 215 x 200 mm Single 197 x 215 x 200 mm Dual	165 x 124 x 124 mm
Heated Build Platform	Yes	Yes (20°C to 100°C)	no
Filament Normally Loaded	1.75mm PLA, ABS, PETG	3mm PLA, ABS, PETG	Photopolymer Resin
Nozzle Diameter	0.40mm	0.40 mm, 0.80 mm	405 nm
Nominal Print Speed	15 mmᶟ/s	30 to 300 mm/s	1-3 cm/hour Z Axis
Resolution	50 microns	20 microns	25 microns
Typical Print Layer Thickness	Coming Soon!	Coming Soon!	25 - 100 μm
Printing Temperature	Coming Soon!	180 ˚C to 280 ˚C	15 ˚C to 30 ˚C
Web Site	Prusa	Ultimaker	Form Labs
User Manual	Manual	Manual	Manual
Hack.RVA Wiki	Write Me!	Ultimaker 3	Form 1+
Firmware Version	3.0.12	3.7.7.20170627	N/A
Serial No.	CZPX2817X003XK26782	BPP-003840-027155	Sassy Leveret
Software	Cura	Cura	Pre Form