Old Laser Cutter: Difference between revisions
Jump to navigation
Jump to search
Aaronn0130 (talk | contribs) Created page with "The laser cutter is being built." |
Aaronn0130 (talk | contribs) initial stab at procedure |
||
| Line 1: | Line 1: | ||
The laser cutter is | The laser cutter is in beta stage. Will be released for member use before not too long. | ||
Here's a wiki [[http://www.hackrva.org/wiki/index.php?title=2.x_Laser_Cutter link to the laser cutter while it was in project phase]]. If you want to know about how it was built etc, go there. | |||
''How to Use the Laser'' | |||
-Turn on computer. | |||
-Turn on laser. | |||
-Make sure coolant is flowing. | |||
-Make sure air is on. | |||
-Make sure all safety guidelines are followed. | |||
*wear eye protection | |||
*no incorrect materials with laser (PVC) | |||
''Creating G-Code with CamBam for the laser" | |||
-set z-clearance plane to 0.001 (temp) | |||
-set depth increment to 0.001 | |||
-set final depth to 0.001 | |||
-set tool diameter to 0.001 | |||
-the rest is normal | |||
Revision as of 12:14, 1 February 2015
The laser cutter is in beta stage. Will be released for member use before not too long.
Here's a wiki [link to the laser cutter while it was in project phase]. If you want to know about how it was built etc, go there.
How to Use the Laser -Turn on computer. -Turn on laser. -Make sure coolant is flowing. -Make sure air is on. -Make sure all safety guidelines are followed.
*wear eye protection *no incorrect materials with laser (PVC)
Creating G-Code with CamBam for the laser" -set z-clearance plane to 0.001 (temp) -set depth increment to 0.001 -set final depth to 0.001 -set tool diameter to 0.001 -the rest is normal