3D Printing

HackRVA has three 3D printers in residence: a Prusa i3 MK3, Prusa i3 MK3S+, Ultimaker 3 and a Form 1+. The Form 1+ is a resin type 3d printer that uses a liquid photopolymer that is selectively hardened by a UV laser on the bottom of a clear tank. The makerspace usually has a selection of generic filament for occasional use. Members should provide their own filament if they are printing a large project or require a specific type.

Here’s a short comparison of the four printers:

	Prusa i3 MK3	Prusa i3 MK3S+	Ultimaker 3	Form 1+
Number of Print Heads	1	1	2	1
Build Platform Envelope	250 x 210 x 200 mm	250 x 210 x 210 mm	215 x 215 x 200 mm Single 197 x 215 x 200 mm Dual	165 x 124 x 124 mm
Heated Build Platform	Yes (Max 120°C)	Yes (Max 120°C)	Yes (20°C to 100°C)	no
Filament Normally Loaded	1.75mm PLA, ABS, PETG	1.75mm PLA, ABS, PETG	2.85mm PLA, ABS, PETG	Photopolymer Resin
Nozzle Diameter	0.40mm	0.40mm	0.40 mm, 0.80 mm	405 nm
Build Speed	up to 15 mmᶟ/s		up to 24 mmᶟ/s	1-3 cm/hr
Resolution	50 microns		20 microns	25 microns
Typical Print Layer Thickness	0.05 - 0.3 mm	0.05 - 0.35 mm		25 - 100 μm
Printing Temperature	Max 300°C	Max 300°C	180–280°C	18–28°C
Web Site	Prusa i3 MK3	Prusa i3 MK3S+	Ultimaker 3	Form 1+
User Manual	Manual	Manual	Manual	Support
Hack.RVA Wiki			Ultimaker 3	Form 1+
Firmware Version	3.11.0	3.11.0	5.3.0.0	N/A
Serial No.	CZPX2817X003XK26782		BPP-003840-027155	Sassy Leveret
Software	PrusaSlicer	PrusaSlicer	Cura	Pre Form 2.20