3D Printing: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 85: | Line 85: | ||
|- | |- | ||
| align="left" | Software | | align="left" | Software | ||
|| | || PrusaSlicer | ||
|| Cura | || Cura | ||
|| [https://wiki.hackrva.org/images/d/d0/EN-Using_PreForm_2.20_with_Form_1%2B.pdf Pre Form 2.20] | || [https://wiki.hackrva.org/images/d/d0/EN-Using_PreForm_2.20_with_Form_1%2B.pdf Pre Form 2.20] | ||
|} | |} | ||
Revision as of 17:28, 19 July 2022
HackRVA has three 3D printers in residence: a Prusa i3 MK2, an Ultimaker 3 and a Form 1+. The Form1+ is a resin type 3d printer that uses a liquid photopolymer that is selectively hardened by a UV laser on the bottom of a clear tank. The makerspace usually has a selection of generic filament for occasional use. Members should provide their own filament if they are printing a large project or require a specific type.
Here’s a short comparison of the four printers:
| Prusa i3 MK2.5 | Ultimaker 3 | Form 1+ | |
|---|---|---|---|
|
|
| |
| Number of Print Heads | 1 | 2 | 1 |
| Build Platform Envelope | 250 x 210 x 200 mm | 215 x 215 x 200 mm Single 197 x 215 x 200 mm Dual |
165 x 124 x 124 mm |
| Heated Build Platform | Yes | Yes (20°C to 100°C) | no |
| Filament Normally Loaded | 1.75mm PLA, ABS, PETG | 3mm PLA, ABS, PETG | Photopolymer Resin |
| Nozzle Diameter | 0.40mm | 0.40 mm, 0.80 mm | 405 nm |
| Nominal Print Speed | 15 mmᶟ/s | 30 to 300 mm/s | 1-3 cm/hour Z Axis |
| Resolution | 50 microns | 20 microns | 25 microns |
| Typical Print Layer Thickness | 25 - 100 μm | ||
| Printing Temperature | 180–280° C | 18–28° C | |
| Web Site | Prusa i3 MK2.5 | Ultimaker 3 | Form 1+ |
| User Manual | Manual | Manual | Support |
| Hack.RVA Wiki | Ultimaker 3 | Form 1+ | |
| Firmware Version | 3.10.1 | 5.3.0.0 | N/A |
| Serial No. | CZPX2817X003XK26782 | BPP-003840-027155 | Sassy Leveret |
| Software | PrusaSlicer | Cura | Pre Form 2.20 |