3D Printing

From HackRVA
Revision as of 15:43, 31 July 2022 by Megan (talk | contribs)
Jump to navigation Jump to search

HackRVA has three 3D printers in residence: a Prusa i3 MK3, an Ultimaker 3 and a Form 1+. The Form1+ is a resin type 3d printer that uses a liquid photopolymer that is selectively hardened by a UV laser on the bottom of a clear tank. The makerspace usually has a selection of generic filament for occasional use. Members should provide their own filament if they are printing a large project or require a specific type.


Here’s a short comparison of the four printers:

Prusa i3 MK3 Ultimaker 3 Form 1+
Prusai3mk2s small.jpg Ultimaker.png Form 1 plus.jpg
Number of Print Heads 1 2 1
Build Platform Envelope 250 x 210 x 200 mm 215 x 215 x 200 mm Single
197 x 215 x 200 mm Dual
165 x 124 x 124 mm
Heated Build Platform Yes (Max 120°C) Yes (20°C to 100°C) no
Filament Normally Loaded 1.75mm PLA, ABS, PETG 2.85mm PLA, ABS, PETG Photopolymer Resin
Nozzle Diameter 0.40mm 0.40 mm, 0.80 mm 405 nm
Build Speed up to 15 mmᶟ/s up to 24 mmᶟ/s 1-3 cm/hr
Resolution 50 microns 20 microns 25 microns
Typical Print Layer Thickness 0.3 - .05mm 25 - 100 μm 
Printing Temperature Max 300°C 180–280°C 18–28°C
Web Site Prusa i3 MK3 Ultimaker 3 Form 1+
User Manual Manual Manual Support
Hack.RVA Wiki Ultimaker 3 Form 1+
Firmware Version 3.11.0 5.3.0.0 N/A
Serial No. CZPX2817X003XK26782 BPP-003840-027155 Sassy Leveret
Software PrusaSlicer Cura Pre Form 2.20