Form 1+

Safety

Follow the Formlabs safety and resin handling guidelines. Resin is a skin irritant and toxic if ingested. Always wear gloves whenever handling resin and wash thoroughly with soap and water if contact occurs.

Procedure for operating the Form 1+ printer

1. Ready your design files in pre-form (support guide located here)

2. Shake resin well and refill vat to maximum fill line. Do not overfill. Larger prints may require that the resin tank is refilled during the print. With the printer paused, open the cover, and slowly add more resin to reach the maximum fill line.

4. Check the resin tank for debris or damage following the instructions on the form website.

5. Send your print your print to the printer from pre-from and press the . Press the Form 1+ button to confirm print.

6. After the print is complete remove the build platform and place it face up in the tray. Be careful not to drip excess resin in or around the printer.

7. Carefully remove the print with a scraper and wipe off excess resin with a paper towel.

8. Wash the print in a plastic lidded container with IPA 95% for maximum 5 minutes. Gently shake/blow off excess IPA quickly and let dry completely. Repeat step 4 to check the resin tank for damage after the print.

9. Place it in the UV oven for 2+ hours to fully cure.